hey guys. ok here is my dilemma. the nx rotor size from the factory is 10.1 i believe. when i look for power slot rotors (only slotted not cross drilled) i see a 10.1 but for vehicles with ABS. that particular rotor wouldn't fit on a nx with no abs right? what rotor do i go with then? 9.8 I see that size for non abs vehicles. what's the part number under powerslot rotors that i should go with? what i'm noticing is that the outer edge of the brake pad is not wearing down (a thin little ridge you can feel) therefore the rotor needs to be a little bigger. i have slotted rotors on my car now (powerslot).

if you have an NX2000 get the parts listed for cars with ABS. Every NX2000 uses the front brake pads/rotors that are listed for cars equipped with ABS even if your car doesn't have ABS. if you get the non abs pads or rotors they will be too small. Those parts are actually the sentra se-r front brakes.

hey guys. ok here is my dilemma. the nx rotor size from the factory is 10.1 i believe. when i look for power slot rotors (only slotted not cross drilled) i see a 10.1 but for vehicles with ABS. that particular rotor wouldn't fit on a nx with no abs right? what rotor do i go with then?

The aftermarket listings for this country are wrong. Always order ABS front rotors and non-ABS rotors for the rear and you'll be fine.

Hint: This has only been covered about 3 million times on here.

Thanks so much... i spent hours trying to figure out the differences in rotor size on different web sites. In the end (before posing the question here) i went with the slotted rotors for a nx with ABS (list's rotor size as 10.1). when they came they are thick and heavy. (part # psr 558psl, 558psr) i didn't put it on yet. but should have no problem installing right? thanks for the info...