|
: Stock Sr16ve ECU with N1 Cams? Raggy 03-08-2008, 12:31 AM If I should get N1 cams and put in the Sr16ve, would the stock sr16ve ecu suffice? would I need a piggyback device to increase fuel and would i need bigger injectors? About how much whp will adding the n1 cams(only) to the sr16motor add? Thanks stracyznski 03-08-2008, 03:38 AM The ecu should handle the N1 cams without any problem. Go for it... soNeoed 03-08-2008, 04:40 AM I have been there and done exactly that (http://forum.pulsar.org.au/showthread.php?t=73665). AFR was good (plot below). I gained 2.4kW after installing the N1 cams in my 16VE. The dyno chart below is 16VE with N1 Cams, N1 manifold, and stock 16VE ECU. http://i144.photobucket.com/albums/r187/soNeoed/VEBuild/SR16VEDyno.jpg Raggy 03-08-2008, 01:03 PM @ soNeoed, I see where u lost power after installing N1 cams! Benito Malito 03-08-2008, 01:34 PM I have heard that N1 do better with less timing and stock 16ve cams take a lot more advance. soNeoed 03-09-2008, 07:17 AM @ soNeoed, I see where u lost power after installing N1 cams! Yeah, I found the intake switch-over point needs to be moved 500rpm higher after fitting the N1 cams. I never got round to doing it though. | ||