alright, I know this is an old video, but it has to be an tubular frame B13 right? My friends have been telling me to convert to awd or rwd and I keep telling them it's almost impossible without a tubular frame.
http://www.youtube.com/v/V7Dw3cQB2aM&hl=en

its possible but alot of time and money

what about nx2k

it doesn't have to be a tubular frame. all you need is the rear subframe from a b12 awd sentra to mock it up. coach did one and it worked out. basically if you find a rear end that will give you the same ratios you're good. one of the hard parts about the awd swap is the fuel tank. the awd one will not work on a b13, its easier to use a fuel cell.

Fake... otherwise they would have shown the whole car on the dyno with all the wheel's spinning.

Fake... otherwise they would have shown the whole car on the dyno with all the wheel's spinning.

the dyno was when the car was fwd still. do you not see when they rev to like 4k and dump the clutch?????? all 4 spin easy.

alright, I know this is an old video, but it has to be an tubular frame B13 right? My friends have been telling me to convert to awd or rwd and I keep telling them it's almost impossible without a tubular frame.
http://www.youtube.com/v/V7Dw3cQB2aM&hl=en

http://i137.photobucket.com/albums/q211/Bluerb240/timeline.gif

http://i137.photobucket.com/albums/q211/Bluerb240/timeline.gif

classic!!!!!!

http://www.sr20forum.com/general-sr20/201197-ever-seen-awd-usdm-sentra-now-u-have.html