Okay, I was changing my clutch yesterday (first time doing it), and we couldn't get the passenger side drive axle out of the tranny because the bolts on the support bearing were too tight. We left the axle in and were able to get the tranny off. My question is, when we go to reinstall the tranny is it going to be a big problem to line up the input shaft and the passenger side drive axle into the tranny? Is there an easier way to get the drive axle out? I just don't want to mess up any seals or mess up the drive axles. Sorry for the panic, but like I said it is my first time doing this and I want to do it right. Thanks in advance for any help.

I'll post a thread once everything is done to tell you guys how it went.