Alright I got my ES bushing kit finally and now I have ordered new Moog ball joints and tie rod ends. I also have motor mount inserts and Im gonna be getting another new motor mount and tranny mount next any info or thoughts on the install of this stuff when I get it all. After this I want to get a new engine and tranny so the car will be almost like brand new. Well not an exact brand new engine more like maybe an Avenir engine.

If you are going to swap the engine, and plan on replacing the tie rod ends, what i would do is wait until the engine is out, then replace both the inner and outer tie rods with nissan parts. If I remember correctly, you can only order the inner and out tie rod as one piece.

With the engine out, it'll be significantly easier to install them.

Aaron

Well I ordered tie rod ends and my repair manual didnt say anything about inner and outer tie rod ends. So hopefuly I got the right thing!

There are inner AND outer tie-rods. The outers screw onto the inners. Pull back the rubber boots on the rack and unscrew them off the rack.