|
dcr1d3r13 07-07-2008, 01:30 PM i need a valve cover bolt one of mine broke and i need to replace it so i can get the car back up and driving if anyone has a set or just a few bolts maybe even just one let me know i would prefer a clean set but anything could work. since im in a hurry. cause4alarm 07-07-2008, 09:53 PM why don't you just rob studs from that $20 motor that you're parting out? there the same thread and pitch just a stud and a nut instead of a bolt while you're at it, take a few extra ones out and send them to me it'll only cost you a stamp. figure that'd be good juju for giving you the heads up. oh and no rabbit with a pancake hunh. dcr1d3r13 07-08-2008, 12:09 AM why don't you just rob studs from that $20 motor that you're parting out? there the same thread and pitch just a stud and a nut instead of a bolt while you're at it, take a few extra ones out and send them to me it'll only cost you a stamp. figure that'd be good juju for giving you the heads up. oh and no rabbit with a pancake hunh. i dont any nuts for the studs i have :( lol what did the rabbit with a pancake on is head come from? dcr1d3r13 07-08-2008, 02:03 PM bump ChronoGN 07-08-2008, 07:52 PM I got some. How many do you need? PM me. dcr1d3r13 07-08-2008, 08:21 PM pm sent dcr1d3r13 07-09-2008, 05:11 PM bump dcr1d3r13 07-10-2008, 12:34 PM bump natethebrown 07-10-2008, 01:40 PM Do you just need the bolts or the grommets that go with the bolts also? I have all the bolts but no grommets (gave them to a friend), less then 20 miles on them. Motor seized up on me due to poor maintenance by the previous owner and me trying to clean the sludge left due to infrequent oil changes. After installing valve cover (with the new bolts, gasket, etc) drove, clogged up oil pump, and left with a seized up engine. | ||