|
gregman_1 08-31-2008, 06:41 PM Trying to change the CPS in my wife's Spec V and can't get the dang connector off. I can't get the sensor out without removing the connector, and I can't see the bottom of the connector to remove it with the sensor in. Someone help! SE-R_TECH 08-31-2008, 06:47 PM Those are the worst. you have to push the connector in while pulling it out. WORST design ever. What ive done is used a pair of needle nose pliers. use one of the tips to push the green part of the connector in. the other end will be on the back of the connector. once the green clip releases squeeze the pliers and pull it off. I hope this makes sense. Ive done hundreds of these since that damn motor came out in 02 SE-R_TECH 08-31-2008, 06:49 PM also if you unbolt the mount for the electrical harness back there it frees up alot of room. gregman_1 08-31-2008, 07:17 PM Those are the worst. you have to push the connector in while pulling it out. WORST design ever. What ive done is used a pair of needle nose pliers. use one of the tips to push the green part of the connector in. the other end will be on the back of the connector. once the green clip releases squeeze the pliers and pull it off. I hope this makes sense. Ive done hundreds of these since that damn motor came out in 02 Makes perfect sense, thanks for the quick answer! Rockwood 09-02-2008, 05:15 PM You should just be able to push it all the way in, then take it off. There's a catch there that until you plug it back in, it'll stay pushed in. | ||