Want to trade this:
http://www.atpturbo.com/Merchant2/merchant.mvc?Screen=PROD&Product_Code=ATP-FLS-056&Category_Code=FLA

For this:
http://www.atpturbo.com/Merchant2/merchant.mvc?Screen=PROD&Product_Code=ATP-FLA-012&Category_Code=FLA

Decided I don't want the 3", it doesn't fit right on my setup so I'd like to get a 2.5" preferably with coupler 2.5 to 3" and t-bolt clamps. I have a 3" coupler with clamps on it also.

is it because it hits the tranny and are you recirculating

not recirculating and yeah it runs into the tranny/motor I probably could shave it and get it to fit but I don't feel like it haha

no i have an inlet pipe that goes from 2.25 or 2.5 that goes to three inch that has a two bolt flange on it

yeah it'll go to 2.25 for the inlet of the turbo but it starts a 2.5". Mine is 3" and just to big to fit it where i want, if it was up top instead of down on the manifold it would be a real nice piece to have.

You got pics?

ill get you one in a lil bit

k cool

What s your e mail adress

got a email from you? but there is nothing there haha

http://us.mc524.mail.yahoo.com/y5/s/viewphoto;_ylc=X3oDMTR1YTFkc2Y3BEFjdGlvbgNUaHVtYm5 haWwgY2xpY2tlZARJbnRsA3VzBExua1R5cANSZWd1bGFyBFBhc nRUeXBlA1lhaG9vIQRSZXNQb3NBAzAEUmVzUG9zUgMEU3JjaEN 1cnIDcGhvdG8EU3JjaERlc3QDcGhvdG8EX1F1ZXJ5SWQDMTE4M jAyMDUzMjQ5MWI3M2YzNjVh
hope this worked

dont know how to post pics

post the link for it

what i did is send them from my phone to email and i dont know how to get them on here ????

send them to your email then email them to me

ericr06988@hotmail.com

need to upload them on photobucket or something