|
Roll-Mod-L 08-27-2002, 09:04 PM I am not sure but I think I spun a bearing again. The first time I did it the sound was very noticable and very loud. This time I'm not sure. I don't really hear it at idle only upon acceleration. Sounds like a knocking sound that gets faster with acceleration. Once I let off the throttle it goes away. Also it is not as loud as when I did it the first time. Somewhat what a valve cover sounds like when its low on oil. chriscar 08-27-2002, 09:59 PM Park the car dude, and save your crank. It sounds exactly like my car did when I spun a bearing. Try pulling one spark plug wire at a time, and see if the noise goes away when you rev the engine. It;s usually the #2 cylinder that goes. Did you run it a little low on oil? Chris NyceP26 08-27-2002, 11:35 PM Damn I hate to hear this. Then again the upside is a JDM motor :) I love mine ;) Sorry to hear the bad news though. Roll-Mod-L 08-28-2002, 07:26 PM I had guys look at the problem. Its not the bearing as I thought, Both said it was the wrist pins between the rod and the piston. Pretty White 08-29-2002, 05:12 AM Time to get Crower rods and a stronger crank. Might as well if you are down in the motor. Why do it twice. Roll-Mod-L 08-29-2002, 07:52 PM Rods and pistons it is!!!! | ||