I have an AEM UEGO Wideband sensor and I was wondering if it can be wired right into a Calum RT (which I also have). If not, how am I supposed to hook it up?
This is all the info I found in the Install manual and an ECU pinout for 95-97 ECU.

The 5 (7 on the 30-2300) wires should be hooked up as follows:

Orange Sensor #1 0-5 Volt Output
White Sensor #1 0-1 Volt Output
Blue Sensor #2 0-5 Volt Output (on 30-2300 only)
Green Sensor #2 0-1 Volt Output (on 30-2300 only)
Brown Signal Ground (use only on systems with a differential input)
Red Switched +10 to +18 Volts (10 Amp Fuse Required)
Black Battery Ground

http://www.roastedpavement.com/stockecu/95-97Pinout.jpg

Bump... would also like to know!

I can't find a pdf for the 30-3300. Is this the gauge controller or the box type?

http://www.aempower.com/ViewCategory.aspx?CategoryID=67

Mine is a gauge.. i think his is too.

Very interested myself too!!! :biggthump

Here is the manual for the latest AEM UEGO that you can purchase: http://www.schnitzracing.com/manuals/AEMWBK.pdf

no, mine is a non gauge type (controller box). Here is the PDF.

http://forum.aempower.com/forum/index.php?action=dlattach;topic=21553.0;attach=437 6

Oh, sorry I just realized the pdf has a typo and says 30-3300. But it is the 30-2300 (Edited it in the above posts)

So, any thoughts yet as of how to hok it up?