I bought this recently from wnwright (aka Nate) and can't use it, as it hits the radiator in my B15 as the radiator sits closer to the block, as opposed to b13 and b14 where the radiator sits further back.

http://i39.tinypic.com/10fw0hu.jpg

Port matched for VE head and ported. 38mm waste gate flange. Dowpipe has wastegate dump tie back into it. Downpipe will be section to under motor you can leave it like that or tie it in with your exhaust... 3" downpipe.

The oxygen sensor bung on the exhaust elbow is welded. And the exhaust elbow and heatshield have a high temp powder coat finish. The manifold has the rattle can ceramic black on it.

Original thread:
http://www.sr20-forum.com/forced-induction/17000-gtir-manifold-modified-external-gate-section-dp.html

Looking for $325 shipped!!! T2 manifold with ext w/g flange, downpipe section, heat shield and j-pipe!!!

Why did it fit in his b15, and not yours? I cant remember if his was a stocker or not... Hmm....

Not sure exactly as my tial was resting on the radiator and nates wasnt. My radiator mounts on the top have been abused over the years and my radiator sits forward some, so that could be it too.

Bump

sell heat shield?