after 2-3 weekends and after work ive gotten the turbo, exhaust manifold and exhaust taken off. Ive also made some modifications to the front bumper support to allow the standard top mount IC to be front mounted. I cleaned up my turbo and exhaust manifold with a few wire brushes, removed some of the casting bumps and irregularities from the inside and outside of the exhaust manifold (its gonna get extrude honed and ceramic coated). Last nite I was in the middle of removing the fuel rail, fuel lines and filter when the misquitos became too much. I must say that i am very disapointed in the condition of my vaccum lines, most of them were dry rotten and i hade to cut them off their ports. I guess its just another excuse to go nuts with some blue silicone tubing.

http://photos.yahoo.com/sir_nixalot69

Where did you get the rear brace bar for the R? Do you know where I can get one off line? And is that a roll bar you have there?

-Mario

got the car with em from japan....they are both Nismo items though...i can see if they have part numbers on them

Would either of those bars work on a 93 nx 2000. That rear one is sweet.

If so where can i get them?

Hey if you don't mind me asking, How hard was it to import? How much? and what do you do for insurance and title??? I want one so bad!



Disregaurd that I didn't see that you are from the islands...Are those plentyful down there?

i think the rear STB is from cusco but im not sure cause its labeled nissan. there are 6 GTiR's on the island