If you guys can show me a pic of it installed on your car,i would appreciate a lot!:)

I can't find anything about it!

I got the say bar but no hardware & i want to see how it supposed to be installed.


B14/200sx

I found this but it's not very clear!

http://www.se-r.net/about/200sx/scc/june97/june26.jpg

damm, I take weeks ago almost the same angle pic of my car .. I hope to take another pic later today to show you how mine it's installed.

Hey thanks a lot mate!

Very easy install, only like 4 bolts i believe. You just have to drill into the beam to create the mounting holes. I will go snap a pic of mine later on as well if this guy doesn't post one for you.

Thanks mate

Still waiting guys,please take a pic for me!

Picture of the two mounting bolts on one side. You shouldn't have to drill anything out to get it up there:
http://www.sr20forum.com/gallery/data/1514/medium/dirtyreargabsL.jpg

orientation:
http://www.sr20forum.com/gallery/data/1514/medium/stswabarr2l.jpg

another:
http://www.sr20forum.com/gallery/data/1514/medium/exhaust2l.jpg

Mike

Mike, you do have to drill to mount the ST bar. On the trailing arm, there is a nut welded to the inside next to where the parking brake cable is bolted to. I think this is for the ABS sensor wire. The nut is closer to the rear of the beam. That is where the rear bolts for the sway bar go. After you have those, you push the car into position and mark for the front bolts. If you haven't already installed it, sell it and get the Stillen rear bar. It's adjustable, doesn't require drilling, and it a much better bar.

Exactly, you already have the location for the rear mounting point so the front is easy to find once you know that. Eric? Why did you recommend the Stillen? Is progress not making theirs any longer?

The progress bars are still in production. You can buy them from Gspec.com

Thanks all of you,i will install it this week end,you guys rock!!!!

You made my day that is all i need