I have a gtir ecu tuned by Stream. I have a consult cable and calumsult. Is there a way I can use this to find out what the ecu is programmed for?

Also, if I cut the wires connecting the daughter board to the main ecu will if run in stock form?

I apologize if these are noob questions but I don't know much about ecu's at all.

Thanks

You dont even need to remove the daughterboard to put the stock tune back in. Just unsolder the zero ohm resistor on the under side of the ECU and move it back to the stock location :) I cant remember the location though but a quick search would bring it up :)