Hi fellow gearheads. I have just finished the install of my EMU and had a Q about the software. When I look at my tables fuel, ignition, etc. I am unable to look all the way at the bottom of the table. It does not load full size. I can scroll left and right to see RPM go all the way to 8K, but I can not scroll down to see all the way to 5V on my MAF voltage. It stops at about 4V. I do not have the vertical scroll arrows and bars like the ones all the way to right of your internet browser, I only have the left to right horizontal scroll bar and arrows like at the bottom of the browser. Anyone know how to fix this? I could get screen shots if it would help. They are on my laptop.

Also with cam and crank sensor hooked up I should see a tach signal on the datalogger, right? I did not hook up a tach signal wire because the instructions said there was no need with the CAM and CRK. I have no tach reference, I'll double check my connections tomorrow.

Any and all help would be appreciated.

Thanks.