My main harness for emanage does not have wires for the injectors for some reason. How can I use the ignition harness for injectors? Which wires from the ignition harness do i use as injectors?

thanks

Adjusting airflow meter values adjusts injector pulse width ;)

This is for emanage to get 150 percent more injector size capacity. you have to splice injector wire from emanage. Without the wires yes the maf reads air in and out but also changes timing without control. You can't just adjust maf airflow and directly adjust fuel without hooking up the ignition harness and injector wires, or else you run into advancing or retarding too much timing. Emanage is almost just like safc without the injector wire and ignition harness hooked up.

Anyone know what I can do on the support tool to recognize the spare wires on the ignition harness as injectors?

Adjusting airflow meter values adjusts injector pulse width ;)

You open up the connector chuck and remove the wires and put them into the main harness one.

There is a sticky in turbo library, explains EXACTLY how to install it.

Dude, I ended up with your b14. Really hope you dont butcher another car. Your last one was very poorly put together.

You are a complete idiot. The car was sold to steveo and then i assume to you. You have no idea what happened after I sold it. Steveo admited that there were no issues with the car when he bought it. He even test drove it and said it was fine. Then he began to have issues. After that he took it to shops and you have no idea what they did unless you were there the whole time. I have sold few cars here and a lot of guys commented how good my car turned out. So in conclusion, get your facts straight first and stay off this thread.

You open up the connector chuck and remove the wires and put them into the main harness one.

There is a sticky in turbo library, explains EXACTLY how to install it.

Dude, I ended up with your b14. Really hope you dont butcher another car. Your last one was very poorly put together.