|
: fitting problem with gt2860rs. benmack1989 10-20-2009, 01:32 PM hey guys. im trying to bolt up my gt2860rs to my pulsar. turbo has a 3 inch intake. when bolted to manifold the inlet on the turbo is against my tranny. no room to put piping on it. any of you guys had this problem before and no of any fixes ??? gti-r93 10-20-2009, 03:20 PM stock manifold? benmack1989 10-20-2009, 03:22 PM have stock manifold, and a stainless header, but the stainless header pushes the turbo back towards the block even more nickr 10-21-2009, 01:44 AM have stock manifold, and a stainless header, but the stainless header pushes the turbo back towards the block even more this makes no sense do u mean u have an aftermarket downpipe and turbo elbow? gtiroz 10-21-2009, 07:01 AM nickr - i think he may be referring to a stock inlet manifold, and an aftermarket exhaust manifold benmack1989 - you might have to grind the block back a bit and/or rotate the comp housing and/or modify the exhaust manifold (reweld the flange at a different angle) and probably also get some new (braided) oil and water lines... benmack1989 10-21-2009, 10:55 AM thanks guys. i posted up on the uk forum and got the same reply, i have a stainless exhaust manifold, what i ment was i have the stock cast one aswell as a stainless one, my bad. but i got her to fit in. thanks for the help guys.. unijabnx2000 10-21-2009, 02:14 PM had to grind block, mine did the same. let me find the pictures unijabnx2000 10-21-2009, 02:21 PM http://i211.photobucket.com/albums/bb110/nx2000det/car/SSL24508.jpg http://i211.photobucket.com/albums/bb110/nx2000det/car/SSL24509.jpg dobby 10-21-2009, 03:02 PM I am sure some people have used a wedge spacer on the manifold to move the turbo away from the block. You could search www.gtiroc.com | ||