anyone make a complete weld-in cage for b14 other than autopower. autopower only does the front half and you use the bolt in back half. and it's too expensive imo. anyone?

http://www.sr20-forum.com/mazworx/25184-u-weld-roll-bars-b13-b14.html

idk if that's what your looking for but ...

http://www.allstarperformance.com/product.htm?prod=785

You can make this kit fit almost any fwd compact car. The price is good and you dont install sandwich plates on the floor this welds to the inside of the rockers. Its a good safe set up.

the kits available through summit and jegs for fox body mustangs and EK civic coupes will fit with trimming-the width is what you need and all the bars will will work with minimal trimming

Kirk Racing (http://www.kirkracing.com/) has one for 4 door B14s.

is this dom tubing? if so I'm very interested as we are doing the 24 hours of lemons in a nx2k in march...
cheers,
don

one more thing.. if not dom what's the advantage over these guys.... http://autoweldchassis.com/rbc.ivnu