OK, after a long battle with not getting no signals from neither the maf or the tps all summer, i finally got some response from the car yesterdaay. The boys and i spent some long hours testing and testing and testing wires. finally, one of my boys went to check the voltage from the maf and its like it jump started the maf. Car revs fine now. Good. Now the tps, we ended up running a wire straight from the tps signal to the ecu. So we are getting signal on the snap on scan tool(.5/closed, 4.85/open). THE PROBLEM: on the laptop and on the e0-1 the tps reading is stuck on 100%. I disconnected the usb cable and it was at zero. We checked the on the tps wire from the emanage and it was showing 2.6v and at the harness where the emanage connects it was showing 5.1. can that be a problem? But even when i press the gas, the tps voltage still doesnt move while testing it from the harness itself. (remember the voltage works properly on the scan tool)