Hello guys,

I habe a problem with my sr20ve. Is this normal or I need a "cap?

http://www.abload.de/thumb/foto766b97m.jpg (http://www.abload.de/image.php?img=foto766b97m.jpg) http://www.abload.de/thumb/foto7682ylm.jpg (http://www.abload.de/image.php?img=foto7682ylm.jpg)

I got a question, im on search for an wire diagramm of engine harness of the Nissan G20 (P11)

Someone got these Wire Diagramms?

Bye
Benjamin

That is the access hole for the SR20VE factory torque converter bolts. You can fit any SR20DE cover in there and Nissan sell them new still for arounds $US12 :)

Ok guys, the engine is in my car. The last problem is the harness. Can u give ma a manuel what cable I must change?

I have a sr20ve harness and the sr20ve ecu. I have the repair manuel from the nx2000, with the harness layout from the sr20de. Can u send me a sr20ve layout? Than I can see with cable I must change.

I hope u can help me and u understand my denglisch :biggthump

Use the G20/P11 wiring loom, it can be fitted to the SR20VE engine once the idle control motor wires are extended a little. Use the P11 distributor and ignition coil. Then you only need to rewire the ECU plug(swap two wires + add the VVL wires) to use the VE ECU :)

There is another forum member from a few years ago from your area of Europe(German or possibly swiss?) who did the swap in his P11. Will try to find his details for you :)