I got the ve in and came to one problem the injectors are not working.
Check the ecu,the 2 grounds,all fuse, fuel pump working, what else control the injectors. everything is stock have not add anything yet.

did u check the sub harness? where the injectors / temp.sensors go plugged into the main harness?

yea i check that need more. sorry i haven't been on but talk to me people.

check for power at the injector plug harness.if you dont get power than check the harness.if still nothing check your ecu for codes.

i do have power at the injector but they r not coming on. when i used the test light u can here the injector come on. so i may them come on so that when i try to start the car it would fire up and it did. so now i have to find time to run back out there to keep messing with it. The n1 that i order last week from gspec have not got here yet. The headers are almost finish. after i beat up on the honga guy around here, (they talk so much crap) then i will go boost.

what about the distributer?

make sure u didnt swap the O2 plug with the plug for the distributer. If you did, u probably have fried the ECU.

If not, take the distributor out and spin the rotor by hand, u should hear the injects click as you spin. If no click, bad distributor

check if its grounded correctly..sometimes the grounds come loose i had a lose injector grounds it was cut a bit so its causes incorrect ground..i haad to check the whole wire it was cut half way..lol..

where is the injector ground.