I have a LO-TEK pod for two of my gauges but I still I have two I need to mount and I want to put them on my bezel. (one in front of my water temp and the other in front to the gas gauge) Does anybody know where to get a Bracket that will screw into my bezel and will hold the gauge in place. I have searched with no success. First one with a answer will get a set of JWT cams!!!!!! Ok, maybe just a thank you.:D

Are you talking about the brackets that hold the gage from the back with 2 nuts? If so, I have some out in the garage for 2" gages. Send me a couple of bucks to cover shipping and I'll send them to you.

I have the little silver brackets that you are talking about. What the hell are those for anyway? I need a bracket that will go around the gauge and then will have a flat part that will screw into the cluster. Does that make sense? If I knew how to post a pic of what I need I would do it..:(

Click the link below and look at my boost gauge in the upper left corner:
http://www.turbochargedse-r.com/serwebpics/mdm100.jpg

Is that what you're looking for? It's an Autometer gauge cup, available anywhere you can buy Autometer stuff. Summit has the best prices, IMHO, as well as Jegs.

Greg, that looks like it will work. Can you still see the stock gauges behind that Autometer gauge? I searched the Autometer site and couldn't find any. I will try the other sites you listed. Hey, while I am asking you a question, do you have a oil pressure gauge? I was looking an old thread you started and I need to get the fittings from the oil sending unit so I can run the oil to my turbo and to my gauge. Thanks

Nope, no oil pressure gauge. Yet. Planning on one over the winter, though, when I re-do the oil tee setup I have.

My boost gauge is the big 2 and 5/8" model, so it's kinda hard to see the water temp factory H-L gauge behind it. You can, it just takes a certain angle to see it clearly. I have a Techtom CMX on the dash anyway, reading out the water temp from the ECU.