I just got my self a b13 shell and before I get the motor in I wanted to clean up the engine bay and re spray it, most likely get the holes filled since it has a wire tuck...

Im trying to see if anyone has any experience with this or if anyone has any advice on
-Whats the best way to strip the engine bay ex. what tools to use that would make it easier to scuff/remove the old paint and be able to get it smooth.

- what to use to fill in little holes and also some body lines inside the engine bay to give it a smooth flow. ( im thinking bondo will possibly crack but not to sure )

Any suggestions would be greatly appreciated...

Here are a few pics of the shell.

http://i94.photobucket.com/albums/l85/hrcbmx/3-13.jpg

http://i94.photobucket.com/albums/l85/hrcbmx/2-17.jpg

http://i94.photobucket.com/albums/l85/hrcbmx/1-17.jpg

http://i94.photobucket.com/albums/l85/hrcbmx/IMG_0468.jpg

http://i94.photobucket.com/albums/l85/hrcbmx/IMG_0453.jpg

http://i94.photobucket.com/albums/l85/hrcbmx/IMG_0449.jpg

ahm... there are some special products polyurethane, but it get hard when its dry and to fill the chasis there is spume too ...anti noise paint can be used later...etc