Has anyone used these? Do they work for Nissans? I am asking because there is a good group buy going on for these. $265 shipped for 440cc injectors.

up

Depends on if they're top feed or side feed, most likely you will have to get a top feed fuel rail (JGY/FTF or JWT). What kinda HP are you looking for? I'm guessing these injectors will topp out at about 325-350

~Ryan

I'm not sure if they are top or side... We have side feed stock right?
They look like ours, kinda shaped like an L but at a 135 degree angle instead of 90.

My setup plan is this: GTIR T28 and manifold. 2.5" Exhuast, test pipe. S4's or HKS 264's. UR 2 Pulley set. 2.5" DP. This is on a 9.5:1 CR motor.

The reason why I'm going with 2.5 insteadof 3 is because I want to limit the power somewhat. I dont want to go over 300WHP.

2.5" wont really limit you(please dont eat me on that one).....youll just get more power down low than 3" pipe *with the T28*

Pretty much all of the GTi-Rs on the UK and *** are running 2.5" or 60mm (UK: Mongoose, Scorpion, Magnex) (Japan: Trust, Apexi, HKS) and they are making bags of power.

I get what your saying but youd be supprised at what power you can make with the 2.5" pipe