Hello everyone!
I am wondering what 300zx maf user's have for filters??? Should I get a MAF adapter plate and put a filter on it, or should I get a pop charger. I have my pop charger from my stock SE-R MAF and I was wondering if I should redrill the holes in it. Thanks again and I am just looking for opinions. Have a good one!

I will be adding the ZX MAF once I go turbo. I will be buying the PR adapter since it is CNC and matches up to the MAF. You may not want to redrill the one you got now since you may get a stumble like I have from my cheap ass adapter. What kind of set are you running now?

I am running a 300zx MAF w/ 50lb inj, and water injection. I just need this last part to complete the project so I can drive my car! I am not looking to put the boost up just yet, I just want to use my car!!! LOL, have a good one and thanks for your response!

My S&B cone filter secures directly to the MAF.

what is an S&B Cone???
I would like to order something so I can get my car running. Thanks

It's very similar to K&N. The K&N filter for the Cobra MAF that FMax uses was backordered or discontinued. The S&B was cross referenced and is the same cone design and filter element. The S&B also has an inward drawn cone on the tip to allow for more surface area than if the tip was a round plate.

Where did you get it??? I would like to order one!

It came with my F-Max stage 2 turbo kit. Give F-Max a call I'm sure they can tell you where to get one. F-Max does not sell to the public anymore.

I'm sorry. When I made my original post I was at work and wasn't thinking striaght. I have a Cobra MAF. However, you should still be able to get a filter that fits. Once again sorry for the false hope.

Thanks for your help. I got my Pop Charger on the MAF now. It worked out better, I went through my whole setup and found a few helpful things! Thanks again for your support and have a good one!

HKS make a cast adapter and filter setup. I pickedone up for $85

K&N Filtercharger ...