I installed my JWT POP charger today and I would like to say that it was well worth the money. Are there any of ya'll that also couldn't really decide where to put that lovely little air temp(?) sensor?

Any suggestions or tips on how to mount that?

BTW, I'm the new guy...
Anyone else in Houston?

[This message has been edited by Johnny GreenBack (edited 02-11-2001).]

With the air temp sensor, if you have a '95-'97, just drill 3 holes in the end of the POP similar to the ones on the stock airbox. If you have a '98+ just leaving it hanging.

------------------
Eric Waterman
1996 200SX SE-R
1997 200SX SE-R
1991 Sentra SE-R
http://www.mindspring.com/~novtec/VTEC_sig.jpg (http://www.mindspring.com/~novtec)

no, from dallas though. maybe a few months I will be down there though. possible $$$$$$$ job.

------------------
98 se-r w/ p/r cai,jwt s3 cams, stillen header, courtesy exhaust, ur pullies, JUN flywheel, ACT clutch, NOS nitrous kit, eibach springs, kyb struts, st sways, cusco camber plates, f/r strut braces, lotsa bushings, and a bunch of other crap not really worth mentioning

Hey, good idea. I ended up making a very narrow spacer between the POP and the bracket with PVC pipe. The sensor is mounted on a flat space ground onto the PVC.