|
hotshotT3 03-23-2003, 07:24 PM ok on my brothers nitrous express solenoid where the purge goes the installer of the kit locktited the screw thing into the solenoid.....now he bought a purge and we went to install it and we cant get the screw out......is their anyway of reversing the lock tite adhesive?? or any ideas on how to get it loose? FastRedB14 03-23-2003, 11:41 PM i hear heating it up helps remove it. however, don't mess up your solenoid. maybe put it in the oven at a couple hundred degrees or so and turn it out. use a quality tool that won't slip and hold it in the vice while turning it out. and for gods sake..lefty loosey righty tighty. SmoothDaddyFig 03-24-2003, 12:44 AM MAN GOOD LUCK!!! I made the mistake of putting the wrong adapter there. I had to drill it out. And it was only on there for 30 minutes!! I would try a heat gun. jon3k 03-24-2003, 10:40 AM Take it back to the guy who loctited it and tell HIM to remove it. What in the world did he do that!? :confused: :eek: hotshotT3 03-24-2003, 11:13 AM yeah man i dont know what to do....i guess i will try to heat it up somewhat and use my craftsman......and if that fails then ill take it back to the guy who installed it SmoothDaddyFig 03-24-2003, 12:32 PM Oh the "installer" did it? DAMN. I hope you get it out!! Purging is SWEEEEEEEEEET. | ||