My endlinks are sitting at a 45 degree angle. Also the bushings that are in them look all contorted and dishovelled. My steering sticks a little and there is a constant creaking at every bump. Does anyone have the instructions for the front sway bar they can e-mail me or scan.

------------------
96 w/ HS CAI, timing @ 17, 92 I/E cams, Naxos muffler, Eibach Sportlines, Front struts: Motivational, Rear shocks: KYB AGX's, S/T sway bars, ES lower control arm bushings and motor mounts, Courtesy F/R STB, APC Clear corners, Stillen grille, and Focus short throw.

http://people.ne.mediaone.net/mgoss/STbars.html

Check out that link. Its on my 98 SE but it should look the same with your 200.

Thanks mike. I was able to put the car up and change the endlinks. It seems the moron who put it in mounted the endlinks in the holes closest to the engine rather than the orignal mounting holes.

[This message has been edited by Bwilsor (edited 06-18-2001).]