I had a good old time yesterdaqy mounting this beast. Dropped the angle grinder on my foot while cutting the center out of the bumper[B)], then later on i proceeded to let it get away from me again and ground off the tip of my middle finger...no foreplay for her for a while[;)][:I]. Anywhos...a little bit of flesh for a front mount intercooler....fair trade in my books. THe piping angles were a little differently than i expected. I have to do 2 90* angles on each side of the cooler to get into the engine bay...working on the piping now

http://www.imagestation.com/picture/sraid61/p95f58fc9429afb62df1a1e60c24d2c9e/fc2bd563.jpg

http://www.imagestation.com/picture/sraid61/pa1d67f6338799e0ac416c50f9c3033af/fc2bd560.jpg

http://www.imagestation.com/picture/sraid61/pd8bb7f3115f8c95d86a2f75eaaefacc3/fc2bd55d.jpg

http://www.imagestation.com/picture/sraid61/p8ac2983379025446f7b8d875bb8c52b2/fc2bd55a.jpg

http://www.imagestation.com/picture/sraid61/pe338a56642b36223195c2605963046b0/fc2bd557.jpg

http://www.imagestation.com/picture/sraid61/pd398415b81ac2db62ef9ee243f84da99/fc2bd551.jpg

http://www.imagestation.com/picture/sraid61/p236b5603c49f2e901046e1fa9567960c/fc2bd550.jpg

wow looks so nice =)

thats a fatty

safety first :rolleyes:

seriously *** that will make for a badass frontmount...lets pray you dont get in an accident.

Sweet looking front mount. Keep us updated with your progress!

Intercooler looks great. Keep up the good work. Peace

-STEVE-0

Damn dude, that thing is huge! i know you don't hear that much, but there is a first time for everything! Just kiddin man. Project looks awesome. About all I did this weekend was get my Progress adj. rear sway bar on and I got the flywheel, clutch, tranny all bolted up and ready to drop. I am waiting on a water pump gasket and that O-ring for the fuel tank access still.

Brent

car ahs one hell of a smile...:D