Any one have them scanned or available to mail me? I went to install them last night and found the plug for the harness is different. These projector weren't made by Nis-Knaks ***. I got them on a group buy from Center Stage Group.

Since you have a 96, your sockets are 9004's right? They should plug right in. But if not, you could just use your current bulbs as wiring harnesses. Take the glass part of the bulbs apart and sodder a wire to each terminal. You can then just splice and crip the corresponding wires to the projector's wiring harness,and WALLAH! You're done and you didn't have to cut up your factory wiring.