What diameter and thread pitch are the bolts that hold the transmission to the engine... I think they are M10x1.5, but not sure. I already searched.
I am taking an engine over to a friends house and helping him put it in an engine stand and I need to buy some bolts on my way over there. This would help out to know what size bolts I need.
THANKS!!

http://www.sr20forum.com/showthread.php?t=49282&highlight=tranny+bolt+size

12x1.75

I got 90mm to hold the engine on a stand; I beleive the stock bolts are 75mm in length

Hi everyone I have a SR20ve and I want to make it turbo. I have a T28R already and I would like 2 make 350hp to the wheels. I know that I have to change the piston 2 a lower compression piston. So I read that using SR20det piston R good 4 the job. My block is already tap and ready 2 go. So what I am asking is there anything I am missing?

Start a new thread. No one will find your question under this thread. Put it in the VE section.