Long story short, clipped a phone pole in my black '91, picked up a red '93 from my mechanic for $150, has a bad motor and no fenders, hood, bumper, headlights, and its an auto, but otherwise it was in better shape than my black car. I already have both motors pulled and the pedals will be an easy swap, but what about the wiring, I didn't find much searching. What can be removed, and how hard is it to separate out. Probably going to skip on the clutch switch if I can.

Hey, MD_emory needs an auto tranny, make a couple bucks and help him out when you pull it.

For wiring, just leave what you have in there, you can ditch the auto tranny ECU in the driver's kickpanel, but that is about it. WAY too much trouble to separate out the wiring.

I've done the auto_manual swap as well as the other way around, so PM me if you need any advice, but going auto to manual is the easier way for sure.

Thankz Rob.........

IM sent

Use the Engine harness 2 from the manual vehicle. Go to my site: http://johnandtracey.com/nissan/tech/transswap for info on the swap.