That's cool. Actually I'm in Huntsville more than Arab. I work out on the Arsenal. I drive my SE-R to work daily. Give me a shout at cedenson@redstone.army.mil

Eric

i had s3 cams in my car, its a bit more laggy than a t25, but think, its a t28 turbo, so it will be a little more laggy.

I think this should be moved to the turbo section.

I think this should be moved to the turbo section.
Agreed and done :)

so i have a t25 that i am rebuilding and it needs a new compressor wheel anyway. can i just bore out the housing and use a T28 compressor wheel? Would there be any gains to that (since i have to allready buy a comp wheel)?

Thinking of grabbing a s15 bb t28 and using that for the hybrid.

My thoughts too! I was thinking a nice takoff ballbearing T28 would be a decent upgrade : )

so where is the best place to get a t28? just the forum?

What happened to the original post?

Also, you get to keep the T25 oil/water lines, intercooler piping, wastegate, downpipe, and manifold correct?

I have a ball bearing T25, will this work on this turbo?

........

what happened? where is the write up? :melonscratcher:

What happened to the write up

bumpity~ anyone got a copy of the missing writeup? :)

Write up..

1. Get T28 center section
2. Machine T25 compressor housing to fit T28 compressor wheel
3. Profit

Write up..

1. Get T28 center section
2. Machine T25 compressor housing to fit T28 compressor wheel
3. Profit

I was hoping for pics, haha! But is the amount that needs to machines do-able with a dremel? or highly reccomended to be done at machine shop?

I was hoping for pics, haha! But is the amount that needs to machines do-able with a dremel? or highly reccomended to be done at machine shop?

Holy crap a dremel? :eek: You really need to take this to a machine shop, or someone that can bore precise holes.

I found two t28 skyline turbo's that are perfect. Will this work? I was told they are t28's but would like to find out for sure. Thanks

damn this is gone now??? ill check the otehr forum

heh, i just finished my t25 and now looking for a little more and this is gone.. WTH

i dont know about putting a t25 compressor housing over a t28 turbo as an upgrade. what we do is put the t28 compressor wheel on the t25 turbo and bore out the t25 compressor housing to fit the t28 compressor wheel. basically u get a t25 with a t28 compressor wheel. will spool like a t25...make powere like a t28! i have a blown t25 and a t28 compressor wheel if anyone is interested in making a hybrid.

how much for the compressor wheel


i dont know about putting a t25 compressor housing over a t28 turbo as an upgrade. what we do is put the t28 compressor wheel on the t25 turbo and bore out the t25 compressor housing to fit the t28 compressor wheel. basically u get a t25 with a t28 compressor wheel. will spool like a t25...make powere like a t28! i have a blown t25 and a t28 compressor wheel if anyone is interested in making a hybrid.