New to the AEM EMS

CoBoss · 05-31-2011, 02:38 PM

I have been trying to use the AEM forum site as well as some of the base calibrations, and cant seem to dial my car in. Its a 1995 240SX, motor is SR20DET Blacktop, CAS disk is installed, 5.2 MAP, I will have to look up my injectors again, I know that they are PR. Right now I am running very little to no boost, being as it is a fresh motor, and would like to break it in easy. I am new to the AEM field of things, but I have been tuning cars out for a long time, Just cant seem to get this one. It has started very few times and idles high, hit the throttle and it dies. If anyone has got any of their base MAPs that I could drop into mine to see if I can figure out the problem, of if anyone can help me at all please shoot me a reply, email or text 330-987-3659

James

scrildo · 06-01-2011, 12:33 AM

The aem 24-1 cas disc is a mojor pos to get dialed in and I bet that that's the reason why you can't get the car running right. Swap in a stock distributor if you have one laying around and start from scratch and use the wizard to select all the sensors that you are running on your car and also make sure you have nissan distributor selected. Coach was a big help to me and also Ben Fenner so see if you can get in contact with them

CoBoss · 06-01-2011, 12:17 PM

I have been trying to go through the wizards to get sensors setup. I dont have an extra distributor laying around, but i do have the stock wheel. I thought that I had to have that CAS wheel in there?

si-r_to_se-r · 06-06-2011, 09:07 AM

you do need that one. make sure its set up for speed density and the wiring is correct.(along with the intake air temp sensor hooked up) the diagram for wiring was confusing to me at first. i struggled with my buddies for a little while but got it running perfect within an hour after i figured out the wiring and what not.