Using Willem

elpiar · 09-15-2007, 11:56 PM

Hi,

I'm new to tuning with nissan ECUs, but I got started already with a calum ECU (I think this is non-realtime one).

I used my old willem from tuning my old hondas to read the ECU but the bin is not read well by TunerproRT. Any hint?

Calum · 09-16-2007, 12:44 AM

I don't support the Willem burners. Once I used a Moates Burn1 my Willem went to the back of the junk drawer, where it has remained.

Assuming the board has 27SF512s, set it up to read starting at 8000, as detailed in the thread below.

http://www.sr20forum.com/calumsult/1...tes-burn1.html

Btw, you'd know if it was a Realtime. :P

elpiar · 09-16-2007, 08:42 AM

Quote:

Originally Posted by Calum

I don't support the Willem burners. Once I used a Moates Burn1 my Willem went to the back of the junk drawer, where it has remained.

Assuming the board has 27SF512s, set it up to read starting at 8000, as detailed in the thread below.

http://www.sr20forum.com/calumsult/1...tes-burn1.html

Btw, you'd know if it was a Realtime. :P

Thanks! I'll give it a shot. I didn't know the start need to be offset.