Green solenoid connector.

Benito Malito · 06-27-2007, 01:31 PM

My engine came with a cracked solenoid connector (the green one on the right) and its gotten progressively worse. I've looked through several harnesses and searched, but can't find an equivalent one to replace it with. If anyone can shed some light on this for me I'd appreciate it.

civicdragon · 06-27-2007, 03:07 PM

have you seen any connector that is the same at all? cause you could just shave the tabs so that it will fit... i know one of them is the same type as the knock sensor plug
I did this for a connector on the distributor.. it was the same style but the tabs were different so i shaved som eplastic off to make it fit

jer_760 · 06-27-2007, 03:10 PM

Quote:

Originally Posted by civicdragon

have you seen any connector that is the same at all? cause you could just shave the tabs so that it will fit... i know one of them is the same type as the knock sensor plug
I did this for a connector on the distributor.. it was the same style but the tabs were different so i shaved som eplastic off to make it fit

Yup, I shaved the tabs on mine also to get my old b14 dist to fit. I still havent had the chance to replace that plug as it is just sitting in there, but it has worked fine so far.

stracyznski · 06-27-2007, 04:35 PM

As they've said above. Shave off the ridges of the male connector on the solenoid. That way any female socket from the injecors, AAC and idiol connectors will fit. And rather then cuting the harness and slicing the harness to the new connector. Get a pin and carefully take the broken female connector appart and refit the wires into the new connector...

Benito Malito · 06-29-2007, 12:03 AM

I thought of doing that but didn't want to try it. Thanks guys.