SR20 Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Hi folks,

Im finishing my motor.

I got forged pistons 11.5:1, eagle rods, new bearings standard size. ARP head studs, cometic head gasket.

So this motor is for my circuit race car, And I was wondering whats the best way to MILEAGE the motor, I know that in a daily drive you should go over 1000kms, not running it more than 5,500 rpm, completing the 1000kms you make the first change oil. and then you can go harder.

BUT IN MY CASE, I DONT KNOW EXACTLY HOW TO DO IT, I DONT KNOW HOW MUCH MILEAGE DO I HAVE TO PUT ON TO MAKE THE FIRST OIL CHANGE.

AND THEN GO TO THE DYNO TO PULL HARDER AND SET UP THE MOTOR.


PLEASE I WILL APRECIATE YOUR ADVICES.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top