[ProjectSE-R]

Hey everyone, got a quick question. I am getting ready to purchase a Ractive red powdercoated strut bar for my 95 200SX SE-R and they only list fitment as being for the 95-99 Sentra. I know the bar will fit the tower bolts, my hesitation is on the height of the engine. Is there any height difference between the 1.6 and 2.0? It is angled as seen in the picture below and I searched the FAQ and prior posts on strut bars but could not determine a definite answer on this. Anyone have any thoughts on this? Will it be ok?

TIA!

John

95 200SX SE-R -- 17's on the way!!!!!

 

[WhiteSER]

It'll fit. Are you getting a rear one also?

 

[ProjectSE-R]

Yeah, but I dont think the same company makes a rear for it, I will double check. May have to go with Stillen or Focuz. I am also in the market for some headers, so if anyone has a set out there for the 2.0, let me know!

C-ya

 

[jacen99SE]

<font face="Verdana, Arial" size="2">Yeah, but I dont think the same company makes a rear for it, I will double check. May have to go with Stillen or Focuz. </font>

Courtesy Nissan has a nice rear strut tower bar. I have one.

 

[WhiteSER]

I got mine for 34.95 each at www.autodynamic.com

 

[97 Black SER]

I have (gulp) the Stillen front strut bar. It's a very nice piece. The red writing even matches the rubber couplers on my hotshot CAI.

------------------
97 Super Black 200sx SE-R
Hotshot CAI, custom 2.5" catback with dynomax super turbo muffler, Hotshot header, UR pulleys (2 set), JWT ECU