SR20 Forum banner

1 - 4 of 4 Posts
G

·
Discussion Starter · #1 ·
Hey guys I got 2 questions I want to ask. I have a Pro kit with KYB shock set and ST swaybars on the way and I need to know if I can do the installation without air tools. and my 2nd question is that my car pulls to the right whenever I'm driving especially starting off a dead stop.( The steering wheel just turns about 45 degrees without me touching it) This has been happening even when I had the car JUST aligned. I'm guessing its my control arm bushings but then again I dont know much about suspensions. Any advice??
 

·
Registered
Joined
·
1,269 Posts
You will enjoy a new suspension cause I know I did. You will not need air tools unless your cat bolts are rusted to hell. Then in that case you will need a torch to get those bolts off. You will need to let the exhaust hang to get the sway bars on, but other than that its a straight foward install. For a novice like my self I didn't find it tough at all expect for drilling in the holes to hold the rear sway bar in tact. You will also need a torque wrench that goes to 18ft/lbs. I have KYB AGX, Sportline, ST F/R Sway bars, F/R STB and does the driving change a big difference. By far the best thing to do. Then you must worry about braking cause with all that handling you will need to stop too you know.

------------------
Peter M.
AIM=NyceP26
97 200SX SER
http://photos.yahoo.com/nyceser
 
G

·
Discussion Starter · #3 ·
Thanks for the advice Peter, and I can't wait till I get the kit hooked up and hit the streets.
 

·
Registered
Joined
·
1,269 Posts
have fun!!!

------------------
Peter M.
AIM=NyceP26
97 200SX SER
http://photos.yahoo.com/nyceser
 
1 - 4 of 4 Posts
Top