SR20 Forum banner

1 - 9 of 9 Posts

·
RE-F/ING-TIRED:)
Joined
·
1,318 Posts
Discussion Starter · #1 ·
does the b14 fsm specify the air gap between the abs pickup sensor and the rear hub reluctor (toothed ring)?
 

·
www.motorists.org
Joined
·
3,047 Posts
Eric? Anyone else with B14 FSM? I ain't got one.


------------------
Ben98SentraSE
98 Sentra SE TURBO
 

·
Registered
Joined
·
3,793 Posts
did you get the right one? you know what I mean....

------------------
98 se-r w/ p/r cai,jwt s3 cams, stillen header, courtesy exhaust, ur pullies, JUN flywheel, ACT clutch, NOS nitrous kit, eibach springs, kyb struts, st sways, cusco camber plates, f/r strut braces,stillen lower control arm brace, lotsa bushings, and a bunch of other crap
 

·
RE-F/ING-TIRED:)
Joined
·
1,318 Posts
Discussion Starter · #6 ·
brian; i haven't had a chance to put them on yet (we had a little quake here yesterday)
but i inspected/measured them and they do seem correct. i'll install them this pm. thanx for all the research you put into it.

novtecser; thanx for your response also.
this confirms my earlier suspicions.

ric/getting the se-r ready for lapping days at pir:)
 

·
Registered
Joined
·
3,793 Posts
ya, I responded before I saw the news. you ok? car ok??

------------------
98 se-r w/ p/r cai,jwt s3 cams, stillen header, courtesy exhaust, ur pullies, JUN flywheel, ACT clutch, NOS nitrous kit, eibach springs, kyb struts, st sways, cusco camber plates, f/r strut braces,stillen lower control arm brace, lotsa bushings, and a bunch of other crap
 

·
RE-F/ING-TIRED:)
Joined
·
1,318 Posts
Discussion Starter · #8 ·
Originally posted by brian:
ya, I responded before I saw the news. you ok? car ok??

i installed the hubs today. these ARE the correct ones. the bearings in the oe rr hub were toast. thanx

ric
97 se-r w/quiet rear end
 
1 - 9 of 9 Posts
Top