SR20 Forum banner

1 - 5 of 5 Posts

·
Big Cheddar fan club
Joined
·
1,466 Posts
Discussion Starter #1
I have a few extra MAFs and my lathe and mill are all fired up now, all I need to know is what size do you bore a stock MAF housing to? I am just kinda doing this for fun but, I want a useable product when I'm done... Any help would be great...

Thanks
 

·
Big Cheddar fan club
Joined
·
1,466 Posts
Discussion Starter #2
Well, I did one and I went 3.5mm oversized. It looks great but, I want to make sure that I am doing it to standard size of everyone else....



Thanks
 

·
Big Cheddar fan club
Joined
·
1,466 Posts
Discussion Starter #4
Thank you very much sir.... I will run a bore guage on it now and see were I am at...
 

·
Big Cheddar fan club
Joined
·
1,466 Posts
Discussion Starter #5
Well, it is now at 54mm and I have set up a program so I can run these things in production. I had nothing better to do at the time. The whole setup came out pretty sweet. Now, I am going to see what else I can do to mess around with Do-it-yourself crap.... Thank you again for the input on the sizes.... :biggthump
 
1 - 5 of 5 Posts
Top