SR20 Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
37 Posts
Discussion Starter · #1 · (Edited)
I am having a problem. I just put in the high port intake cam and everything went smoothly. I drove the car for about 60 miles and it was ok. But while I was driving, almost reaching 70 miles, the car stalled on me on a turn. It turned back on no problem but it just dies right away. I turned it on again and held the rpms above 1k. The motor ran fine but once I drop the rpms the motor dies. The motor was at operating temperature. When I swapped the cam, I noticed it has Bosch Platinum 4 spark plugs. The plugs looked good. The sparked plugs wires are good and so are the cap and rotor. Cam timing is correct. Can anyone help me out?
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top