SR20 Forum banner
1 - 1 of 1 Posts

·
You like that, dontchya?
Joined
·
956 Posts
<font face="Verdana, Arial" size="2">Originally posted by mismo42:
I don't have a manual so I was hoping you guys could let me know if there is anything wierdto look for? (NX200, atinlock brakes) OH yeah, do the pistons push in, like with a c clamp, or screw in?
</font>
Get your rotors turned so the pads will bed-in easier. Make sure you have enough meat on them - the machine shop should be able to tell you if you're ok.

The front caliper pistons you can push in (by hand if you're strong enough), the rears you have to twist in with some needle nose pliers.

Check se-r.net for some tips!

Good luck!

------------------
Antonio Garcia
91 SE-R w/ lots of stuff
a slow [email protected] on JWT 50 shot
Bay Area, CA

[This message has been edited by AntonioG (edited 09-13-2001).]
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top