Hey guys..about to install a aftermarket clutch..any suggestions on what I should replace? (ex..any seals, gaskets..etc.) Thanks guys! Plus any tricks or tips on getting that badboy installed would also be appreciated.
Be shure to replace t/o bearing and reface the flywheel. While your in there do the bushing in the end of the crank and axle seals. Nismo makes a needle bearing to replace the stock bushing if you want p/n 32202-09500. Thats about it a fsm might help. good luck.
hi,
i just bought a set of second hand jwt s4 cams for my sr20, but i don't have the instalation sheet of the cams.
I want to degree the cams with an adjustable cam gear so i need the specs from the cams to do so.
Is there anybody who has this sheet (picture) for me?
The jwt website i can,t...
Hey Guys
Am Converting My Sr20de to + T just wondering if anyone has any pics of location and size and measurements on the hole in the fire wall for the clutch pedal?
Also location of where i put the slave cylinder and lines etc
That would be much appreciated
Cheers
Hi I have a 1998 Nissan 200sx se r 2.0L
My starter went out and I want to know where the starter located.
i would like some pictures if anybody has any or explain to me where it is.
thank you
Hi Folks, I am new here and trying to get some information pertaining to a SR20DET swap.
I have a SR20DET from a liberty that I am trying to install into my B14 Sentra. I was trying to mate this with a LSD gearbox from a P11 with the P11 axles. Besides the outer joints being a different size...
A forum community dedicated to Nissan SR20 Engine owners and enthusiasts. Come join the discussion about performance, builds, turbos, modifications, troubleshooting, maintenance, and more!
