SR20 Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
419 Posts
Discussion Starter #1
Ok,guy's i need some feed back on some high
performance clutches.. i got quite a few mods
on my se-r all bolt-on and my clutch is slipping pretty bad...have any suggetions???
 

·
Registered
Joined
·
909 Posts
Im going with the JWT pressure plate with a 2000 stock clutch disk. This what I had on my 200 and am ordering another for the NX monday.

MarC
 

·
Veritas
Joined
·
6,205 Posts
ProActive is the clutch in my '93. So far, 106 dragstrip launches (@ 5,000+ rpm), with nary a blip of protest from the clutch.
The ProActive unit is designed to carry up to 100hp over stock, btw.
Cost? About $300 plus installation.

------------------
Greg Perry, '93 SE-R w/ 149,000 miles, JWT pop, header, ProActive
clutch, ST bar, NOS direct-port 75hp, Autopower 4-point roll bar/harnesses.
[email protected] 1/4 mile, [email protected] 1/8 mile, 1.98 60-ft.

My SE-R page, with videos
 
G

·
Guest
Joined
·
0 Posts
Anybody have a part number to the act clutch? I looked at a few differnet sites and it looks like there are 5 different ones? I just want better than stock and be able to hold 200 ft lbs at the most. My stock is slipping--so now is the time. Also--anybody know of a cheap store--online or off for act?

thanks
mark

------------------
93 se-r
so stock--it is scary
 

·
Off-Topic lurker..
Joined
·
3,122 Posts
MarC, what do you mean, JWT Pressure Plate and 2000 stock disk?

------------------
Aztec Red 1993 NX2000
 
1 - 7 of 7 Posts
Top