SR20 Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
64 Posts
Discussion Starter · #1 ·
I have a 93' se-r and I just did a tune-up. But the only thing it's still doing is it will bounce around when I start it. It idles fine after it warms up (800rpm), and when it finally stops and is warming up it's at about 11-1200rpm's. But right when I start it the belts squeek (not enough to make me think it's the belts) and it will go from 300 to 1100 and almost stall like 4 times. Any ideas of what it might be? I'm clueless.
 

·
Registered
Joined
·
450 Posts
I'm going to be my old "state the obvious" self. But mine would do it if I haven't cleaned the TB in a while. It usually happens if it has been started once b4 that day (meaning it isn't ice cold and the gum around the plate is just tacky enough to wrestle with it during startup)

Hope its that easy for you.
 

·
Registered
Joined
·
359 Posts
Doesn't sound like it's the TB since the TB stays closed during startup - air's passing through the AICV instead. Could be the O2 sensor also.
 
1 - 5 of 5 Posts
Top