ok. there is a 92 NX sitting in a junkyard nearby. the flywheel is already off the engine sitting in the back seat. Is it possible to just pick up that bad larry and cart it over to a any machine shop to have a few pounds shaved off? or do only certain shops do this, do they need a schematic? any tips?
I will be re-doing my tranny in the next year I suspect, since it was already off the motor this looked like a good idea on paper, but then again what I know about engines couldn't fill one side of a yellow sticky.
Dave
I will be re-doing my tranny in the next year I suspect, since it was already off the motor this looked like a good idea on paper, but then again what I know about engines couldn't fill one side of a yellow sticky.
Dave