SR20 Forum banner
1 - 4 of 4 Posts

·
Boost Junkie
Joined
·
69 Posts
Discussion Starter · #1 · (Edited)
FS: INCON GTBB37 Miko Special EWG - BRAND NEW! - SOLD!!!!!

I have for sale an INCON GTBB37 Turbocharger. Yes, this is one of the ones that Andreas Miko modified quite some time ago. It is currently setup for external wastegate use as you can tell in the fourth photo in this ad. This turbocharger was bought second hand from another member on this site (ITR_KILLR) and has been sitting since purchase. The turbo has the same specs as a Garrett GT3076R only the turbine side has been ported to allow more air to flow through it. This turbocharger has never been used by me or the previous owner. It was bought brand new from Andreas Miko. I'm not sure what Andreas charged for them brand new back in the day when you COULD get them. I'm asking $800 FIRM for it (shipping and Paypal extra). If you are local, pick up is welcomed. The rust on the turbine housing is from mounting the turbocharger up to my SR20DET and leaving it for a week outside in a covered shed. The housing can be beadblasted at no additional cost for you if you would like prior to purchase. The turbocharger is located in Simpsonville, SC which is near Greenville. If you need to reach me on this immediately send me an e-mail to thagr81_us at hotmail dot com or you can PM/reply to this thread, but you will most likely receive a delayed response, as I don't have a computer at my apartment. Photos of the turbocharger can be seen below (click thumbnails to enlarge). Thanks for taking the time to view my ad and if you have any questions, don't hesitate to ask.

Also, as you may have noticed the rust on the turbine housing. This was due to sitting in the humid air in a shop in South Carolina one summer. This has since been beadblasted to look brand new again.








 

·
Boost Junkie
Joined
·
69 Posts
Discussion Starter · #2 ·
Also forgot to list the specs on this...

· Incon Systems GTBB37.
· Compressor --- Ind. x Exd. 55 mm x 76 mm 52 trim A/R .60
· Turbine --- Exd. x Ind. 53.5 mm x 56.5 mm 90 trim A/R .86
· Dual Ball bearings.
· Water Cooled center section

The CHRA part # is 700177-0011
 

·
Boost Junkie
Joined
·
69 Posts
Discussion Starter · #4 ·
This turbo is SOLD!!! Thanks SR20Forum.
 
1 - 4 of 4 Posts
Top