SR20 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
232 Posts
Discussion Starter · #1 ·
I have searched all over the place but was unable to find directions to install the Greddy rocker arm stoppers! Any help would be appreciated.. They look straight forward and I see you have to etch the VC, but I just want to make sure there aren't any tricks!
 

·
Registered
Joined
·
244 Posts
it is straight forward.unbolt all the cam caps in the order the service manual says.put em on and retorque the caps in order.the valve cover i don't know.everyone says you don't have to notch anything.but i could never get mine to fit right after i put mine on.i even notched where it looked like it was catching but it still is very tight puting it on.
 

·
FWD PWNAGE IS HERE!
Joined
·
2,570 Posts
You have to make sure that the cams are at 10 and 12 otherwise when you go to bolt the intake cam down it wont work... still havent put mine back on lol. That's about it...
 
1 - 3 of 3 Posts
Top