SR20 Forum banner
1 - 3 of 3 Posts

· Get Some!!
863 Posts
Discussion Starter · #1 ·
What's everyone's take on this? Anyone bored their engine? Port/Polish? Balance/Blueprint?

I know our engine handles 2.5x stock HP w/out much internal work but it's still interesting to talk about.

Jason N. -- '92 Black Classic
JWT Cams
JWT POP Adapted to:
HS Header
2 1/2" Pipe in CAT's Place
GReddy Cat Back
NT555 Drag Radials on 2 stock 14x5.5s.

· Registered
969 Posts
I extruded the head and intake manifold and tb housing .all I know is that I drive at 70 mph on 5th at
3150 rpm. also good on gas if you can control the hammer foot

91 SE-R,10:1 comp.pistons,balanced &blueprint rebuild.comp.4angle valve job,extrude honed heads/intake manifold,No emissions.crap,RC TB/MAF,nismo cams,UR pulleys,stillen4-1 ceram.header,nismo/centerforce dual fric.clutch,PR CAI,2 1/2 test pipe,mandrel 2 1/4 superturbo ex.,and a whole bunch of other goodies! boost is in the works ,hell yeah 3:16!
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.